CCNA 4 English V3.1 - WAN Technologies

NETLAB_AE supports Networking Academy CCNA Course 4 labs using:

The table below lists the supported labs and pod types which can be used. Labs in CCNA4 not listed below are not currently supported by NETLAB_AE.

Enabling the Labs

To enable CCNA labs and pod types, check the box for "AE CCNA 4 English V3.1" in the class settings. This must be done for each class requiring access to CCNA4 labs.

Using the Labs

Always select the correct lab exercise for the lab being performed.

Students or teams should schedule the correct lab exercise from the catalog. NETLAB will only show those labs for which the required pod type is available. If your system supports multiple pod types, some labs may appear more than once in the catalog. Instructors should select the correct lab from the Exercise tab during instructor-led lab reservations. This can be done as many times as needed during the reservation.

Importance of Choosing the Correct Lab Exercise

Several of the labs differ from the standard pod topologies. This is handled by NETLAB's Dynamic VLAN Mapping technology. Always select the correct lab exercise for the actual lab. This insures that NETLAB will set up VLANs on the control switch such that lab devices and PC's are placed in the correct LAN segment for the exercise being performed.

Supported Lab List

Course	Lab	Description	Pod Required	Comments
CCNA4	1.1.4a	Configuring NAT	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	1.1.4b	Configuring PAT	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	1.1.4c	Configuring Static NAT address	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	1.1.5	Verifying NAT and PAT configuration	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	1.1.6	Troubleshooting NAT and PAT configuration	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	1.2.6	Configuring DHCP	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	1.2.8	Configuring DHCP relay	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	3.1.7	Troubleshooting a Serial Interface	BRPv1, BRPv2, or CRP	PCs not required
CCNA4	3.3.2	Configuring PPP Encapsulation	BRPv1, BRPv2, or CRP	PCs not required
CCNA4	3.3.3	Configuring PPP Authentication	BRPv1, BRPv2, or CRP	PCs not required
CCNA4	3.3.4	Verifying PPP Configuration	BRPv1, BRPv2, or CRP	PCs not required
CCNA4	3.3.5	Troubleshooting PPP Configuration	BRPv1, BRPv2, or CRP	PCs not required
CCNA4	4.2.1	Configuring ISDN BRI (U-Interface)	ARP
CCNA4	4.3.2	Configuring Legacy DDR	ARP
CCNA4	4.3.7	Configuring Dialer Profiles	ARP
CCNA4	5.2.1	Configuring Frame Relay	ARP or CRP
CCNA4	5.2.2	Configuring Frame Relay PVC	BRPv1, BRPv2, or CRP	PCs recommended
CCNA4	5.2.5	Configuring Frame Relay Subinterfaces	ARP or CRP